Filing a claim is easier with good records. We document everything and talk to your adjuster for you.
Certified technicians, professional drying equipment and moisture readings you can see for yourself. No guesswork.
The sooner drying starts, the less there is to repair. Our phones are answered around the clock, with same-day visits when available.
Most people who call us have never dealt with crawl space water removal before. We walk you through it on the phone, then send a local crew with the right equipment.
Water under the house is easy to miss. It tends to turn up as a damp chill underfoot, a stale smell at the vents, or a small lake discovered the day somebody lifts the hatch. At that point the batts are typically saturated and the framing overhead has sat damp for several days. Our team pumps the water out, clears what is ruined and dries the framing before it softens.
Once the standing water is gone, the job is only halfway done. Wood framing takes water in gradually and gives it up just as gradually, which is why we meter the joists, beams and subfloor and leave dehumidifiers on until readings drop, typically 3 to 5 days. Finding the cause matters just as much, since a dripping water line, a failed drain or groundwater from a storm will flood the area again unless it is addressed.
Damp wood and wet soil are exactly what termites, carpenter ants and rodents look for. Getting moisture levels down takes away a main reason for them to stay.
Because air naturally moves upward from under the home, spores and stale odors in a wet crawl space reach your living areas too.
Saturated soil can soften around footings and let piers settle or lean. You might notice it as a door that suddenly rubs or a floor that is no longer level.
Under a typical house you will find cable runs, electrical boxes and duct lines. Wires under water can shock someone, and wet duct wrap pushes a moldy smell through every vent.
Nobody enters until the space has been screened for shock risks, hanging ducts and contamination. After that our team marks out the wet area and records how much moisture the framing and subfloor hold.
Standing water comes out with submersible pumps and hoses, down to the footing trenches and dips where it gathers. While pumping, the crew also cleans off the sediment the water left on the plastic.
Debris, saturated batts and any liner that cannot be reused leave the crawl space in bags. Our crew then wipes down the uncovered framing and applies antimicrobial to spots with growth or a high chance of it.
Low profile air movers and a dehumidifier run under the house until the wood reaches a normal moisture reading. A final meter check follows, and you receive the numbers along with steps to prevent a repeat.
Water collects in the low spots and soaks into the soil. Batts begin drawing moisture upward and the air below the house turns humid quickly.
Mold can start on damp joists and paper faced insulation. Wet batts get heavy and begin to pull away from the subfloor.
The moisture starts reaching the part of the house you live in. The lumber goes on taking in moisture, a stale smell spreads and flooring can begin to cup.
Lumber left damp this long starts breaking down. Expect softer framing, rusted fasteners, and a wet environment that draws in termites and similar pests.
It depends on the material, how long it stayed wet and how clean the water was. We test before we decide, and we tell you why.
Ask a Tech: (623) 352-0605| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Floor joists | Joists that got wet and stay sound when tested with an awl | Sections with deep rot or punky wood that cannot hold weight |
| Sill plates | Treated lumber that dries out and stays hard at the anchor bolts | Rotted or crumbling lengths, often near corners and vents |
| Pipe insulation | Rubber or foam wrap that stayed out of the water | Wrap that soaked through or was touched by contaminated water |
| Vapor barrier | Undamaged liner we can rinse and spread back out | Plastic that is torn, buried in silt or holding water below it |
| Subfloor panels | Unswollen sheets of plywood where screws still bite | Panels that puffed up, split into layers or crumble, particle board above all |
Not seeing your question? Call and ask. It costs nothing to talk it through.
Call (623) 352-0605Don't wait for small problems to become expensive emergencies. Call Lynchburg Restoration for fast, reliable service.
Call (623) 352-0605 Now